NOTE: When adding a job to the queue, the button at the bottom of the page becomes Remove,
allo
wing you to remove the job from the queue and return it to its initial location.
When you add a job while printing, sacrifice layers are added between jobs; see diagram below.
A job can be added only if there is enough height available for it. Take into account that the height
required is the printed height plus the sacrifice layers between jobs.
You cannot add a job while the current job is annealing.
NOTE: Adding a complex job during printing may slow down the processing of the current job, which
could cause prin
ting problems.
Cancel a job
You can cancel a job while it is printing.
74 Chapter 8 Print
To Next Page
Loading...