Table 3-4 Beacon
Graphics State Description
White light The printer is ready.
White moving light The printer is printing or preparing to print.
Yellow light
The printer can print, but there is something wrong. If the problem
per
sists, contact your support representative. While printing, you will
see a yellow instead of a white light.
Red light
The printer is unable to print and needs attention, or a major
sub
system of the printer is not working.
Change system options
You can change various printer system options from the front panel.
Tap the Settings icon , then System.
● Date and time options to view or set the printer's date and time.
● Speaker volume to change the volume of the printer's loudspeaker. Select Off,
Low, or High.
● Front panel brightness to change the brightness of the front-panel display. The default brightness is
50
.
● Unit selection to change the units of measurement in the front-panel display. Select English or
Metric. By default, units are set to Metric.
● Restore factory settings to restore the printer settings to their original values as set in the factory.
T
his option restores all of the printer settings except the Gigabit Ethernet settings.
Change system options 29
To Next Page
Loading...