7. Insert the internal glass by pulling the metallic clip.
8. Add the frame with the bottom glass, securing it with four screws.
Reassemble the fusing-lamp module
1. Turn the assembly upside down and put it back into the print carriage.
2. Tighten the captive screw.
3. Plug in the black power connector.
4. Plug in the gray sensor connector.
5. Put back the cover.
Finish the replacement
1. Close the top cover.
2. Turn on the printer.
3. At the front panel, tap the Settings icon
, then Utilities > Maintenance > Replace parts >
Replace heating/fusing lamps.
4. Dispose of the old fusing lamp according to local regulations.
Processing station
The processing-station consumables include material cartridges, bulk material supplies, and storage
and e
xternal tanks.
Material
Material is the basic ingredient used to build parts.
Material states
● Reusable: Material that can be reused
● Waste material: Used material that should not be reused
● Mixed: A mixture of new and used material, by default up to 80% used
132 Chapter 11 Hardware maintenance
To Next Page
Loading...