If you need to cancel the job while printing, tap Cancel and confirm it in the build status app on the
printer's home screen. The printer will cancel the job.
IMPORTANT: When printing with TPU material, if you cancel during the annealing process, your parts
may have major print-quality issues. HP does not recommend canceling.
IMPORTANT: Wait until the printer tells you it is safe to remove the build unit.
Proceed with the cooling process and unpacking if relevant. If no parts have been printed, the build unit
should be cleaned and loaded before using it again.
Check status on the front panel
You can monitor the status of the current job from the front panel.
At the printer’s front panel, the Build status icon
on the home screen shows you the status of the
build curr
ently being printed.
● Status of the job: A progress bar shows the phase completed. The phases are warming, printing, and
annealing (if selec
ted when the job was sent to print).
● Estimated finishing time
● Job name
● Layers printed and layers in total
● Parts printed and parts in total
● Height printed and total height
● Material type
You can select an isometric or section view of the current layer, and you can navigate through layers.
Check status on the front panel 75
To Next Page
Loading...