Take the following precautions:
● Use the power supply voltage specified on the nameplate.
● Connect the power cord to a dedicated line, protected by a branch circuit breaker according to the
inf
ormation detailed in the site preparation guide.
● Call your service representative if the built-in Residual Current Circuit Breaker (Ground Fault Circuit
In
terrupter) is repeatedly tripped.
● Do not insert objects through slots in the equipment.
● Take care not to spill liquid on the equipment. After cleaning, make sure all components are dry
be
fore using the equipment again.
● Do not use aerosol products that contain flammable gases inside or around the equipment. Do not
oper
ate the equipment in an explosive atmosphere.
● Do not block or cover the openings of the equipment.
● Do not attempt to modify the top heating, fusing, build chamber, e-cabinet, or enclosures.
● Proper maintenance and genuine HP consumables are required to ensure that the equipment
oper
ates safely as designed. The use of non-HP consumables may present a risk of fire.
● Take special care with zones marked with warning labels.
● Do not place objects covering top cover, enclosures, or air ventilation.
● Do not leave tools or other materials inside equipment after maintenance or servicing.
Suitable materials for fire-fighting include carbon dioxide, water spray, dry chemicals, or foam.
CAUTION: Do not use a jet of water, as it could scatter and spread the fire.
WARNING! Depending on the material used, some unhealthy substances can be released into the air
in case o
f incidental fire. Wear self-contained pressure-demand breathing apparatus and full
protective gear. Your EHS specialist should consult the Safety Data Sheet (SDS) about each material,
available at
http://www.hp.com/go/msds, and advice on the appropriate measures for your location.
Mechanical hazard
The equipment has moving parts that could cause injury.
To avoid personal injury, take the following precautions when working close to the equipment:
● Keep your clothing and all parts of your body away from moving parts.
● Avoid wearing necklaces, bracelets, and other hanging objects.
● If your hair is long, try to secure it so that it will not fall into the equipment.
● Take care that sleeves or gloves do not get caught in moving parts.
● Avoid standing close to the fans, which could cause injury and could also affect print quality (by
ob
structing the air flow).
● Do not operate the equipment with covers bypassed.
10 Chapter 2 Safety precautions
To Next Page
Loading...