Move or store the product
This topic explains the concepts involved in this subject.
IMPORTANT: If your HP Jet Fusion 3D Printing Solution needs to be moved to a different location or
room, you should contact your reseller for assistance. This product has sensitive components that can
be damaged during tr
ansportation: special transportation features and tools are needed.
If you need to move the processing station slightly within the same flat room, without steps or using
r
amps to change level, do it carefully. You may need to do this in order to perform tasks such as cleaning
the working area, or small maintenance operations such as filter replacements. In this case, move it on
its own wheels only over smooth, flat surfaces, within a room higher than 2.5 m (8 ft 2 in). Do not attempt
to go up or down steps, and make sure there is no risk of knocking the station, which could cause serious
damage. For any other movement, contact your reseller for assistance.
Take care that connecting cables do not damage any painted surfaces, bellows, and so on.
Do not move the printer for any purpose without service assistance. Additional packing precautions and
installation calibrations are required for significant displacements of the equipment.
To store the printer, processing station, and build unit for an extended period of time (longer than a
weekend), first clean each device, ensuring that there is no material left inside:
● See:
Clean the print zone, carriage, and housing structure on page 151
● See: Clean the working area on page 280
● See: Clean the processing station on page 283
● See: Empty the material from the build unit on page 60
● See: Check and clean the interior of the build unit on page 68
Material extracted must be kept within the storage conditions of the material. The equipment should
be s
tored at a temperature of −25°C to 55°C-13°F to 131°F and humidity of less than 90% (without
condensation). Before using it again, allow at least 4 hours for it to acclimatize to operating conditions,
and check for condensation before turning it on.
For a shorter period (one weekend), if you want to keep material inside the product, the product
operating conditions must be met.
324 Chapter 11 Hardware maintenance
To Next Page
Loading...