Clean the loading nozzle sensor
Take the loading nozzle and use the hand air blower to blow air on the inner part.
IMPORTANT: Do not touch the sensor.
If you can see that the sensor is still dirty, or if you accidentally touched it with your hand, wipe
the sensor glass clean b
y rubbing the surfaces lightly with a lint-free cloth moistened with a general-
purpose industrial cleaner, such as Simple Green industrial cleaner. Then immediately wipe it dry with
another clean, soft, all-cotton cloth or cotton swab.
Clean the working area
The following sections provide details for this topic.
Prepare for cleaning
The following steps provide the complete procedure for this topic.
280 Chapter 11 Hardware maintenance
To Next Page
Loading...