Grade 1: Light cleaning
Light cleaning is sufficient when the materials are relatively compatible.
Perform the following operations:
● See: Empty the material from the build unit on page 60
● See: Check and clean the interior of the build unit on page 68
● See: Clean the processing station on page 283
● Daily printer maintenance: see Printer maintenance on page 147
Grade 2: Deep cleaning and material purge
Deep cleaning should be used when the materials are not compatible.
Perform the following operations:
● See: Empty the material from the build unit on page 60
● See: Check and clean the interior of the build unit on page 68
● See: Clean the processing station on page 283
● See: Purge the processing station on page 56
NOTE: You will need 30 liters of the new material (15 liters from each of the supplier connectors),
to be used for purging.
For the printer, follow these steps:
1. Turn off the printer (see Turn the printer on and off on page 37).
2. Clean the print zone, carriage, and housing structure on page 151.
3. Clean the inside of the carriage on page 175.
4. Clean the service-station caps on page 177.
5. Clean the top-enclosure fan filters on page 180.
6. Clean the print-zone window on page 210.
7. Clean the bottom glass of the heating lamps on page 199.
8. Clean the front bar (after every job/daily) on page 157.
9. Clean the scan-axis wipers on page 173.
10. Clean the bottom of the carriage and of the fusing lamps on page 161.
11. Clean the fusing-lamp glasses on page 190.
12. Clean the recoating roller and recoating plates on page 167.
13. Clean the spittoon on page 158.
14. Clean the thermal camera glass on page 163.
Grade 1: Light cleaning 55
To Next Page
Loading...