4. Vacuum the wiper hole until there is no material left in it.
5. Vacuum the wipers until there is no material left on them. Additionally, you must use a lint-free cloth
dampened with general-purpose industrial cleaner. If the wipers present a high accumulation of
material and the curtain is not properly cleaned after the required maintenance frequency, please
contact your HP support representative to proceed with the replacement of the part.
6. Inspect the scan-axis wiper status. If there is clustered powder that cannot be removed with
vacuum, and the felt is damaged, it must be replaced. The following picture shows an example of a
damaged scan-axis wiper.
Finish cleaning
1. Put the wipers back in place, and fasten them with the screws.
CAUTION: If you print before putting back the wipers, material can fall outside the printer.
2. Close the top cover.
3. Ensure that all windows, covers, and doors are closed and remain in their original positions.
4. Turn on the printer.
Clean the inside of the carriage
Cleaning inside the printer.
Figure 11-9 Safety warnings
Prepare for cleaning
1. Ensure that you have an explosion-protected vacuum cleaner (not provided by HP).
Finish cleaning 175
To Next Page
Loading...