1. Check the whole processing station for dust, material, or aerosol on covers, doors, and so on.
2. If necessary, clean the processing station further using a vacuum cleaner with a soft brush nozzle.
3. Additionally, you can wipe it with a dry cloth.
Clean the processing station
The following steps provide the complete procedure for this topic.
You may sometimes decide to clean the processing station without purging it, in order to remove the
mat
erial inside it.
NOTE: After cleaning, some residual material may still remain in the processing station. You can
r
emove more of the material by purging.
1. You are recommended to replace the external tank with a new one. Otherwise, the process may be
interrupted when the tank is full.
2. At the front panel, tap the Settings icon , then Material management > Clean the processing
station.
3. Ensure that the external tank is closed, and that the external-tank collector pipe is connected to the
cover.
4. Place the sieve connector on the reusable material collector and connect it to the sieve.
Clean the processing station 283
To Next Page
Loading...