1. Ensure that you have an explosion-protected vacuum cleaner and an absorbent all-purpose cloth
(these things are not provided by HP).
2. Remove the build unit.
3. You are recommended to wear gloves and goggles.
Clean the working area
The following steps provide the complete procedure for this topic.
1. Open the hood.
2. Remove the perforated metal sheet from the working area.
3. Clean the whole working surface, including under the perforated metal sheet, and the edges of the
build unit using an explosion-protected vacuum cleaner.
NOTE: Make sure the platform control button area is clean.
4. Clean the front and sides of the processing station using an absorbent all-purpose cloth.
5. Clean the perforated metal sheet, away from the processing station, using an absorbent all-
purpose cloth.
Clean the working area 281
To Next Page
Loading...