4. Unscrew the captive screw at the front of the fusing module and disconnect the wires.
5. Pull the fusing-lamp assembly sideways and then toward you.
6. Take the fusing-lamp module out of the carriage and place it gently on a table.
Safety precautions for the fusing-lamp emitter
● Disregard of the safety precautions or improper operation of the infra-red (IR) emitter can lead to
injurie
s and material damage.
● The IR heating device should be operated only by specialists or trained personnel.
The operator of the system should compile specific instructions for personnel training.
● The safety and functional reliability of the IR heating device are guaranteed only if you are using
original acce
ssories and spare parts from HP.
● After an emitter break, a dangerous voltage may be exposed to contact by the heating spiral.
● The reflector side should not be cleaned.
Safety precautions for the fusing-lamp emitter 129
To Next Page
Loading...