Clean the printer
1. Vacuum all the top-cover surfaces including the heating-lamp quartz-glass zone and the left and
right filters.
NOTE: If the internal metallic part is dirty, clean it with a lint-free cloth dampened with water.
2. Clean the dust from the print zone using an explosion-protected vacuum cleaner with a soft brush
nozzle.
CAUTION: When vacuuming the scan axis or recoater curtains, do not push too hard against the
cur
tains: they could bend inside and slip out of their guides.
3. Vacuum the whole print carriage and capping zone. Move the print carriage manually if necessary.
Additionally, you must use a lint-free cloth dampened with general-purpose industrial cleaner to
clean the surfaces. Make sure that the carriage is dry before printing.
CAUTION: When moving the print carriage manually, do it slowly, and be careful not to crash it into
an
y other component or the sides of the printer.
Clean the printer 153
To Next Page
Loading...