by the detergent manufacturer). Then rinse the glass with another cloth dampened with
deionized water, and wipe it with a dry cloth.
b. If necessary, clean the glass with a sponge scourer.
c. Continue cleaning the glass with the cloth and sponge scourer until it is completely clean.
d. Wait until the glass is dry to start printing.
3. Wipe the sensor glass clean by rubbing the surfaces with a clean, soft, all-cotton cloth or cotton
swab dampened with a mixture of mild, non-abrasive detergent and deionized water (in proportions
recommended by the detergent manufacturer). Then rinse the sensor glass with another cloth
dampened with deionized water, and wipe it with a dry cloth.
CAUTION: Clean only the sensor glass: try to avoid wetting any other parts of the printer.
CAUTION: If the sensor glass is left to dry by itself, it may become permanently stained.
Clean the thermal camera glass 165
To Next Page
Loading...