2. Ensure that the printer is not printing.
3. Turn off the printer.
4. If a job has just been printed, wait about 20 minutes for the printer to cool down.
5. You are recommended to wear gloves.
6. Open the top cover.
7. Move the print carriage manually to the left to access the capping station.
CAUTION: When moving the print carriage manually, do it slowly, and be careful not to crash it into
an
y other component or the sides of the printer.
Clean the service-station caps
Table 11-10 Warning labels
Risk of burns Crush hazard Risk of trapped
finger
s
Hazardous moving
part
Light radiation
hazard
Electric shock
hazard
For more safety information, see Safety precautions on page 4
178 Chapter 11 Hardware maintenance
To Next Page
Loading...