Table 2-1 Warning labels (continued)
Label Explanation
Risk of burns. Let the equipment cool
down before accessing internal parts.
You are required to wear gloves when
handling mat
erial cartridges, agents,
printheads, the printhead cleaning roll,
and when performing maintenance and
cleaning tasks. Chemical protection
gloves are suitable, and should be tested
according to EN 374.
● Glove material: NBR (nitrile rubber)
● Thickness > 0.11 mm (0.0043 in)
● Breakthrough time > 480 minutes
(permeation leave 6)
You are recommended to wear a pair
of heat-resistant gloves per person
when unpacking parts in the processing
station. The temperature can be up to
200°C (392°F), depending on the material
being processed.
You are recommended to wear a safety
mask when r
eplacing filters.
During the first seven full-build-chamber
jobs you are required to use a mask with
filter type A (according to DIN 3181) for
vapors of organic compounds.
You are required to wear tightly fitting
saf
ety goggles:
● For the first seven full-build-
chamber jobs
● When replacing filters
● For maintenance and cleaning
tasks
Do not step over the support platform of
the mat
erial cartridges.
16 Chapter 2 Safety precautions
To Next Page
Loading...