4. Remove four more screws.
5. Move the material extraction system 5 mm to the front to disengage the positioning pins, and
remove it vertically.
6. Insert the new kit and position it using the pins.
7. Attach it with the four new screws provided with the kit.
8. Close the door.
9. Put back and tighten the two screws.
10. Repeat the process with the other door.
Safety maintenance of the printer
Check the functionality of the Residual Current Circuit Breakers (RCCBs)
Following standard RCCB recommendations, it is recommended that the RCCBs are tested on a yearly
basis. T
he procedure is as follows:
1. Turn off the printer from the front panel, not using the service switch.
Safety maintenance of the printer 275
To Next Page
Loading...