4. Remove the filter.
Finish replacement
The following steps provide the complete procedure for this topic.
1. Install the new filter. Notice that the arrow should appear in the upper part of the filter.
2. Place the cover.
3. Put back the 4 screws.
4. Reset the filter after installation. Go to front panel > Settings > Utilities > Maintenance > Replace
parts > Reset e-box fan filter counter.
Safety maintenance of the processing station
Check the functionality of the Residual Current Circuit Breaker (RCCB)
Following standard RCCB recommendations, it is recommended that the RCCB is tested on a yearly
basis. T
he procedure is as follows:
1. Turn off the processing station from the front panel, not using the service switch.
296 Chapter 11 Hardware maintenance
To Next Page
Loading...