An example is shown below. The yellow lines represent areas with possible defects; the red lines
represent areas with probable defects; the blue ellipses enclose parts affected by the defective
nozzles. On the left, a number of parts are affected by yellow and red lines; on the right, the parts
have been rearranged so that only one part is affected by a yellow line.
For reference, the location of each printhead and die with respect to the bed is shown below.
3. Replace the affected printhead(s).
If the printhead recovery is not sufficiently effective, you can choose to replace a malfunctioning
prin
thead with a new one.
What to do when the printheads show these defects 341
To Next Page
Loading...