7. Once the print job has been lifted into the natural cooling unit, put the slicing blade back in place.
Make sure the front flap and the slicing blade are in the correct positions.
CAUTION: Ensure that the slicing blade is fully inserted, and that the slicing-blade flap is closed.
8. Remove the natural cooling unit from the processing station, using a forklift.
CAUTION: If any material spillage is detected, make sure the slicing blade is closed, and clean up
the mat
erial with an explosion-protected vacuum cleaner.
NOTE: HP recommends transporting the natural cooling unit in the lowest position of the forklift,
t
o avoid it falling.
9. After cleaning, the build unit will be ready for a new print job.
Extracting the build to the natural cooling unit 87
To Next Page
Loading...