Changing the default resolution setting
Resolution, in dots per inch (dpi), affects the quality of faxed documents. It also affects the
transmission speed as a higher resolution produces a larger file, which requires more time
to transmit. The factory-set default resolution setting is Fine.
Use this procedure to change the default resolution for all fax jobs to one of the following
settings:
ā Standard: This setting provides the lowest quality and the fastest transmission time.
ā Fine: This setting provides a higher resolution quality than Standard that is usually
appropriate for text documents.
ā Superfine: This setting is best used for documents that mix text and images. The
transmission time is slower than Fine but faster than Photo.
ā Photo: This setting produces the best images, but greatly increases the transmission
time.
To change the default resolution setting
1. Press
MENU
/
ENTER
.
2. Use the < or the > button to select Fax setup, and then press
MENU
/
ENTER
.
3. Use the < or the > button to select Fax Send setup, and then press
MENU
/
ENTER
.
4. Use the < or the > button to select Def. Resolution, and then press
MENU
/
ENTER
.
5. Use the < or the > button to change the resolution setting.
6. Press
MENU
/
ENTER
to save the selection.
Note
For instructions about changing the resolution for the current fax job only, see To adjust the
resolution for the current fax job.
ENWW Changing the default resolution setting 35
English
To Next Page
Loading...
