HP M8501 - Page 5

Contents
M8501 and M8502 ACL Tape Drive Installation and User’s Guide—529972-001
iii
Tables
Figure 2-2. Installing the Slide Members 2-3
Figure 2-3. Installing Slide Member Fasteners 2-4
Figure 2-4. Tabletop Model Clearances 2-5
Figure 3-1. Hardware Configuration 3-2
Figure 3-2. Tape Drive’s Fibre Channel Port Connection 3-3
Figure 3-3. LC-LC Fiber Cable 3-4
Figure 3-4. View of Two FCSAs at the Rear of the Server 3-5
Figure 3-5. Powering On the ACL Tape Drive 3-6
Figure 3-6. Status Button 3-7
Figure 3-7. Drive 1 LTO Loaded Button 3-8
Figure 3-8. Drive Identification Button 3-9
Figure 3-9. Viewing the Portname 3-10
Figure 4-1. Front Panel 4-1
Figure 4-2. Magazine Door Mechanical Release 4-2
Figure 4-3. Initialization Screen 4-3
Figure 4-4. ACL Default Screen 4-4
Figure 4-5. Technical Support Information 4-5
Figure 4-6. Access Magazine Screen 4-6
Figure 4-7. Move Media Screen 4-6
Figure 4-8. Move Media Screen (Source) 4-7
Figure 4-9. Move Media Screen (Destination) 4-7
Figure 4-10. Power Down Initiation Screen 4-8
Figure 4-11. Status Screen 4-9
Figure 4-12. Menu Screen 4-10
Figure 4-13. View ACL Options Screen (Initial Screen) 4-11
Figure 4-14. Tape Magazine With Tape Cartridges Installed 4-14
Figure 4-15. Barcode Label Installation (LTO) 4-15
Figure 6-1.
Troubleshooting Flow Chart 6-2
Tables
Table 1-1. Models and Slot Capacities 1-2
Table 3-1. Fiber Cables 3-3
Table 4-1. ACL Front Panel Indicators 4-2
Table 4-2. View ACL Options 4-11
Table 6-1. Error Recovery Procedures 6-3
Table 6-2. Fault Symptom Codes 6-3