EasyManua.ls Logo

HP M8501 - Page 68

HP M8501
78 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Troubleshooting
M8501 and M8502 ACL Tape Drive Installation and User’s Guide529972-001
6-12
Fault Symptom Codes (FSCs)
SMX send error A001 C, G An attempt to place a message on a
task’s exchange generated a kernel error.
SMX receive error A002 C, G An attempt to receive a message from a
task’s exchange generated a kernel error.
Comm free list empty A003 C, G An attempt to acquire a message from the
free pool failed because the pool is empty.
Invalid comm. put
attempt
A004 C, G An attempt to place a message on a
task’s exchange failed because either the
argument message pointer was NULL or
the argument exchange pointer was
NULL.
Invalid comm. get
attempt
A005 C, G An attempt to receive a message from a
task’s exchange failed because the
argument exchange pointer was NULL.
Comm initialization
error
A006 C, G The Comm manager could not be
initialized at power-up because the
system is out of memory.
Put of a NULL comm. A007 C, G An attempt to place a Comm block on a
task’s exchange failed the argument
Comm block pointer was NULL.
Msg contains no
comm.
A008 C, G A message obtained from the free pool
did not contain a Comm block.
Comm return address
in unknown
A009 C, G An attempt to return a command
response to the originating task failed
because the originator could not be
determined.
Bad Image CRC F001 F The uploaded firmware image has a bad
CRC and is probably corrupted.
Flash erase sector
failed
F002 F One of the flash memory sectors could
not be programmed.
Flash program sector
failed
F003 C, G One of the flash memory sectors could
not be erased.
Bad flash CRC F004 C, G The firmware image programmed into
flash memory has a bad CRC and is
probably corrupted.
Flash exit error F005 C, G Internal flash task error.
Incompatible image F006 F The uploaded firmware image is not
compatible with the ACL hardware,
possibly an older firmware version.
Buffer allocation failed F402 F The flash task could not allocate a buffer
area to hold the firmware image to be
uploaded.
Table 6-2. Fault Symptom Codes
Message FSC ERP

Table of Contents

Related product manuals