HP NonStop NS-series

Printers and Terminals: Monitoring and Recovery
HP Integrity NonStop NS-Series Operations Guide—529869-005
12-3
Recovery Operations for Printers and Terminals
This listing shows that the three collector processes, $S, $S1, and $S2, are active and
none is approaching a full state. The data shown in the report means:
Recovery Operations for Printers and
Terminals
For more information, refer to Related Reading on page 12-3.
Recovery Operations for a Full Collector Process
If the SPOOLCOM COLLECT display shows any collector process approaching 90
percent capacity, jobs must be deleted from the collector in question.
Related Reading
For more information about printers in your environment, refer to the vendor
documentation.
For more information about printers and terminals connected to a SWAN concentrator:
•
WAN Subsystem Configuration and Management Manual
•
Asynchronous Terminals and Printer Processes Configuration and Management
Manual
For information about the spooler and SPOOLCOM:
•
Guardian User’s Guide
•
Spooler Utilities Reference Manual
COLLECT The name of the collector process
STATE The current state of the collector process, which can be ACTIVE,
DORMANT, DRAIN, or ERROR
FLAGS The current SCF substate of the collector process
CPU The processor number of the collector process and its backup
process
PRI The execution priority of the collector process (The default value is
145.)
UNIT The number of 512-word blocks requested by the collector process
when it needs more disk space (The default value is 4.)
DATA FILE The name of the disk file where the collector process stores jobs
%FULL The percentage of the data file that is full