HP Integrity NonStop NS-Series Operations Guide—529869-005
15-1
15
Starting and Stopping the System
When to Use This Section on page 15-2
Powering On a System on page 15-2
Powering On the System From a Low Power State on page 15-3
Powering On the System From a No Power State on page 15-3
Starting a System on page 15-5
Loading the System on page 15-5
Starting Other System Components on page 15-9
Performing a System Load on page 15-9
Performing a System Load From a Specific Processor on page 15-11
Reloading Processors on page 15-12
Minimizing the Frequency of Planned Outages on page 15-14
Anticipating and Planning for Change on page 15-14
Stopping Application, Devices, and Processes on page 15-14
Stopping the System on page 15-16
Alerts on page 15-16
Halting All Processors Using OSM on page 15-16
Powering Off a System on page 15-17
System Power-Off Using OSM on page 15-17
System Power-Off Using SCF on page 15-17
Emergency Power-Off Procedure on page 15-18
Troubleshooting and Recovery Operations on page 15-18
Fans Are Not Turning on page 15-18
System Does Not Appear to Be Powered On on page 15-19
Green LED Is Not Lit After POSTs Finish on page 15-19
Amber LED on a Component Remains Lit After the POST Finishes on page 15-19
Components Fail When Testing the Power on page 15-19
Recovering From a System Load Failure on page 15-20
Getting a Corrupt System Configuration File Analyzed on page 15-21
To Next Page
Loading...
