To Next Page

To Previous Page

Creating Startup and Shutdown Files

HP Integrity NonStop NS-Series Operations Guide—529869-005

16-18

Printer Line Startup File

This example shows an SCF command file that starts a printer line associated with the

SWAN concentrator $ZZWAN.#S01 (configuration track-ID X001XX).

This file can be invoked automatically from the STRTSYS file, or you can invoke it by

using the following TACL command:

> SCF / IN $SYSTEM.STARTUP.STRTLP, OUT $ZHOME /

== This is $SYSTEM.STARTUP.STRTLP

== Starts the printer associated with the SWAN concentrator

== $ZZWAN.#S01

ALLOW 20 ERRORS

START LINE $LP5516

Expand-Over-IP Line Startup File

This example shows an SCF command file that starts an Expand-over-IP

communications line from $ZZLAN.LAN08, at IP address 192.231.36.094, to \Case2, a

NonStop K-series server at IP address 192.231.36.089.

This file can be invoked automatically from the STRTSYS file, or you can invoke it by

using the following TACL command:

> SCF / IN $SYSTEM.STARTUP.IP2CASE2, OUT $ZHOME /

Note that the IP addresses used in this file are examples only. If you use this example

file on your system, you must change these IP addresses to IP addresses that are

appropriate for your LAN environment.

== This is $SYSTEM.STARTUP.IP2CASE2

ALLOW 100 ERRORS

START LINE $Case2IP

Expand Direct-Connect Line Startup File

This example shows an SCF command file that starts an Expand direct-connect line on

a SWAN concentrator.

This file can be invoked automatically from the STRTSYS file, or you can invoke it by

using the following TACL command:

> SCF / IN $SYSTEM.STARTUP.STRTLH, OUT $ZHOME /

== This is $SYSTEM.STARTUP.STRTLH

START LINE $Case2elh

HP NonStop NS-series User Manual

Questions and Answers: