Configuring and Expanding Your Computer
Installing a RAM Expansion Module
86 Reference Guide
4. Insert the RAM board into the connector at about a 30° angle until it is fully inserted.
Then press down at both sides until both latches snap closed.
5. Replace the cover.
6. Insert the battery.
To remove a RAM expansion module
You may want to remove a RAM module so you can install a larger one. You’ll need a
small Phillips screwdriver for these steps.
CAUTION
Your computer’s chips are extremely sensitive to static electricity, and can be
permanently damaged by it. Handle the RAM module only by its edges. Before
installing the memory module, discharge your body’s static electricity by touching
the metal shielding around the connectors on the rear of the computer.
1. Click Start, Shut Down, Shut down.
2. Important: Unplug the ac adapter, if present, and remove the battery. Remove the
secondary battery if one is installed.
3. Turn the unit bottom-side up, remove the screw holding the RAM cover, and remove
the cover.
To Next Page
Loading...
Need help?
General