HP OmniBook 900

Installing Accessories
Using the Module Bay Adapter
1-40
To install the module bay adapter
WARNING
8SEZSMHVMWOSJIPIGXVMGEPWLSGOVIQSZIXLITS[IVGSVHJVSQXLITS[IVSYXPIX
FIJSVIVIQSZMRKXLIXSTGSZIVSJXLIHSGO%PWSVIQSZIER]RIX[SVOGSRRIGXMSRW
ERHHMWGSRRIGXER]I\XIVREPHIZMGIW%P[E]WVITPEGIXLIXSTGSZIVSJXLIHSGO
FIJSVIXYVRMRKXLIHSGOSREKEMR
Important
You will need a medium-sized Phillips screwdriver to install your module adapter.
1. Undock the OmniBook.
2. Disconnect all cables connected to the rear of the dock.
3. Disconnect the power cord from the dock.
4. Remove the Kensington lock, if attached.
5. Remove the dock tray, if installed.
6. Remove the five screws securing the top cover to the base.