To Next Page

To Previous Page

8-2

Link Layer Discovery Protocol (LLPD)

LLDP Configuration

Table 8-1. LLDP Configuration Fields

■ Click Apply to save any changes for the current boot session; the changes take effect

immediately. Use the Maintenance > Save Configuration page to have the settings remain in effect

after a reboot.

To view LLDP statistics, click Status > LLDP Statistics in the navigation pane.

Field Description

Global

Transmit Interval Specify the interval at which frames are transmitted. The default is 30 seconds, and the

valid range is 5–32768 seconds.

Transmit Hold Specify the multiplier on the transmit interval to assign to TTL (range 2–10, default = 4).

Re-Initialization Delay Specify the delay before a re-initialization (range 1–10 seconds, default = 2).

Notification Interval Specify a limit for the transmission of notifications (range 5–3600 seconds, default = 5).

Interface

Interface The port to be affected by these parameters.

Transmit Enable Enable or disable the transmission of LLDP PDUs. The default is enabled.

Receive Enable Enable or disable the ability of the port to receive LLDP PDUs. The default is enabled.

Enable Notification Enable to have LLDP generate a log file entry.

Transmit Mgmt Info Enable or disable the transmission of management information with the LLDP PDUs. The

default is enabled.

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 1810G and is the answer not in the manual?

HP ProCurve 1810G Specifications

General