Hardware options installation 52
15.
Connect the BP1 power connector of the LFF power cable to the 4-bay LFF hot-plug drive cage
backplane.
16. To connect the 4-bay LFF hot-plug drive backplane to the onboard controller, connect the 520-mm
Mini-SAS cable:
a. Connect the Mini-SAS cable to the system board.
b. Route the Mini-SAS cable along the side of the system board towards the front chassis, and then
connect the cable to the drive backplane.
c. Secure the Mini-SAS cable in the right front chassis cable clip.
d. Install the air baffle (on page 29).
e. Install the primary PCI riser cage ("Install the PCI riser cages" on page 27).
17. To connect the 4-bay LFF hot-plug drive backplane to an HBA option, connect the 540-mm Mini-SAS
cable:
To Next Page
Loading...
