Hardware options installation 54
d.
Install the air baffle (on page 29).
e. Install the primary PCI riser cage ("Install the PCI riser cages" on page 27).
f. Route the Mini-SAS cable along the side of the system board towards the front chassis, and then
connect the cable to the drive backplane.
g. Secure the Mini-SAS cable in the right front chassis cable clip.
18. To connect the 4-bay LFF hot-plug drive backplane to an HPE Smart Array P-series Controller
option, connect the 540-mm Mini-SAS cable:
a. Identify the riser slot compatible with the new option, and then remove the cover opposite from
that slot.
To Next Page
Loading...
