The following image illustrations a typical 50°C configuration.
Figure 7-61 50°C configuration
50°C radial fan
The 50°C configuration requires a radial fan assembly is installed in the optical drive bay.
To replace the radial fan assembly:
1. Prepare the computer for disassembly (
Preparation for Disassembly on page 41).
2. Remove the access panel (
Access Panel on page 42).
3. Raise the drive cage to its upright position.
4. Disconnect the fan cable from the system board connector labeled CHFAN2 (1).
5. Remove the fan cable from the clips built into the top of the heat partition (2).
50°C configuration components 99
To Next Page
Loading...
