HP rp5800 User Manual

Table 2-4 Computer Setup—Security (continued)
Password Options
(This selection appears
only if a power-on
password or setup
password is set.)
Allows you to enable/disable:
● Lock Legacy Resources (appears if a setup password is set). Default is enabled.
● Setup Browse Mode (appears if a setup password is set) (allows viewing, but not changing,
the F10 Setup Options without entering setup password). Default is enabled.
●
Password prompt on F9, F11, & F12 (allows access to menus without entering setup
password). Default is enabled.
●
Network Server Mode (appears if a power-on password is set). Default is disabled.
See the Desktop Management Guide for more information.
Smart Cover (some
models)
Allows you to:
● Lock/unlock the Cover Lock.
● Set the Cover Removal Sensor to Disable/Notify User/Setup Password.
NOTE: Notify User alerts the user that the sensor has detected that the cover has been
removed. Setup Password requires that the setup password be entered to boot the computer if
the sensor detects that the cover has been removed.
This feature is supported on some models only. See the Desktop Management Guide for more
information.
Device Security Allows you to set Device Available/Device Hidden (default is Device Available) for:
● Embedded security device (some models)
● System audio
● Serial ports (some models)
●
Parallel port (some models)
●
Network controllers (some models)
●
SATA0
●
SATA1
● SATA2 (some models)
●
SATA4 (some models)
●
eSATA (some models)
USB Security Allows you to set Enabled/Disabled (default is Enabled) for:
● Front USB Ports
◦ USB Port 1
◦ USB Port 2
◦
USB Port 3
◦
USB Port 4
●
Rear USB Ports
◦
USB Port 1
◦ USB Port 2
Computer Setup (F10) Utilities 9

HP rp5800 Specifications

General

Processor	Intel Core i3-2120 (3.3 GHz, 3 MB cache, 2 cores)
Memory	4 GB DDR3
Storage	500 GB SATA (7200 rpm)
Operating System	Windows 7 Professional (64-bit)
Ports	VGA, DisplayPort, serial, parallel, audio in/out, RJ-45
Power Supply	240W