Table 3-6 Jetdirect menus (continued)
Menu item Sub-menu item Sub-menu item Values and Description
DHCPV6 Policy Router Specified: The stateful auto-configuration method
to be used by the Jetdirect server is determined by a router.
The router specifies whether the Jetdirect server obtains
its address, its configuration information, or both from a
DHCPv6 server.
Router Unavailable (default): If a router is not available, the
Jetdirect server should attempt to obtain its stateful
configuration from a DHCPv6 server.
Always: Whether or not a router is available, the Jetdirect
server always attempts to obtain its stateful configuration
from a DHCPv6 server.
Primary DNS Use this item to specify an IPv6 address for a primary DNS
server that the Jetdirect server should use.
Secondary DNS Use this item to specify an IPv6 address for a secondary
DNS server that the Jetdirect server should use.
Proxy Server Specifies the proxy server to be used by embedded
applications in the product. A proxy server is typically used
by network clients for Internet access. It caches Web pages,
and provides a degree of Internet security, for those clients.
To specify a proxy server, enter its IPv4 address or fully-
qualified domain name. The name can be up to 255 octets.
For some networks, you may need to contact your
Independent Service Provider (ISP) for the proxy server
address.
Proxy Port Type the port number used by the proxy server for client
support. The port number identifies the port reserved for
proxy activity on your network, and can be a value from 1
to 65535.
Idle Timeout The time period, in seconds, after which an idle TCP data
connection is closed, and can be a value from 0 to 3600
(default is 270 seconds, 0 disables the timeout).
Security Secure Web For configuration management, specify whether the
Embedded Web Server will accept communications using
HTTPS (Secure HTTP) only, or both HTTP and HTTPS.
HTTPS Required: For secure, encrypted communications,
only HTTPS access is accepted. The Jetdirect server will
appear as a secure site.
HTTPS Optional (default): Access using either HTTP or
HTTPS is permitted.
IPSec Specify the IPSec status on the Jetdirect server.
Keep: IPSec or firewall status remains the same as currently
configured.
Disable (default): IPSec or firewall operation on the
Jetdirect server is disabled.
ENWW Basic configuration using the Administration menu 25
To Next Page
Loading...