Table 3-6 Jetdirect menus (continued)
Menu item Sub-menu item Sub-menu item Values and Description
802.1X Reset 802.1X settings to factory defaults.
Reset: Reset 802.1X settings to factory defaults.
Keep (default): Retain current 802.1X settings.
Announcement Agent Set announcement agent preferences.
Enable(default): Enable the announcement agent.
Disable: Disable the announcement agent.
Reset Security Specify whether the current security settings on the
Jetdirect server will be saved or reset to factory defaults.
Yes: Security settings are reset to factory defaults.
No (default): The current security settings are maintained.
Diagnostics Embedded Tests LAN HW Test Yes: Run a LAN hardware test.
No (default): Do not run a LAN hardware test.
HTTP Test Yes: Run an HTTP test.
No (default): Do not run an HTTP test.
SNMP Test Yes: Run an SNMP test.
No (default): Do not run an SNMP test.
Data Path Test Yes: Run a data path test.
No (default): Do not run data path test.
Select All Tests Yes: Select all tests.
No (default): Do not select all tests.
Execution Time (H) Set the time delay, in hours, for test execution. When you
click Execute, the selected tests will execute after this
interval. Valid values are 0–24, default is 1.
Execute Yes: Execute the selected tests..
No (default): Do not execute the selected tests.
Ping Test Dest Type Select the destination type for this test.
IPV4 (default)
IPV6
Dest IPv4 Enter the IP address for the IPv4 destination.
Dest IPv6 Enter the IP address for the IPv6 destination.
Packet Size Specify the packet size for this test. Valid values are 64–
2048, default is 64.
Timeout Set the timeout value for this test. Valid values are 1–100,
default is 1.
26 Chapter 3 Administration - Configure the product ENWW
To Next Page
Loading...