Table 3-6 Jetdirect menus (continued)
Menu item Sub-menu item Sub-menu item Values and Description
Count Set the count value for this test. Valid values are 0 –100,
default is 4.
Print Results Yes: Print test results.
No (default): Do not print test results.
Execute Yes: Execute the selected tests..
No (default): Do not execute the selected tests.
Ping Results Packets Sent Number of packets sent. Valid values are 0–65535.
Packets Received Number of packets received. Valid values are 0–65535.
Percent Lost Percent of loss. Valid values are 0–100.
RTT Min Valid values are 0–4096.
RTT Max Valid values are 0–4096.
RTT Average Valid values are 0–4096.
Ping in Progress Yes
No
Refresh Yes
No
Link Speed The link speed and communication mode of the Jetdirect
server must match the network. The available settings
depend on the product and installed Jetdirect server. Select
one of the following link configuration settings:
CAUTION: If you change the link setting, network
communications with the Jetdirect server and network
product might be lost.
Auto (default): The Jetdirect server uses auto-negotiation
to configure itself with the highest link speed and
communication mode allowed. If auto-negotiation fails,
either the 100TX Half value or the 10T Half value is set
depending on the detected link speed of the hub/switch
port. (A 1000T half-duplex selection is not supported.)
10T Half: 10 Mbps, half-duplex operation.
10T Full: 10 Mbps, full-duplex operation.
100TX Half: 100 Mbps, half-duplex operation.
100TX Full: 100 Mbps, full-duplex operation.
100TX Auto: Limits auto-negotiation to a maximum link
speed of 100 Mbps.
1000T Full: 1000 Mbps, full-duplex operation.
ENWW Basic configuration using the Administration menu 27
To Next Page
Loading...