To Next Page

To Previous Page

1 = No (default)

2 = Yes - on a new physical port set

2. At this point, you have configured the network sufficiently to enable access to the StoreOnce

Management CLI and GUI. If preferred, you could complete the network wizard and carry

out the rest of the network configuration using the StoreOnce CLI commands. For the purposes

of our example, we shall continue to create a second portset on the pair of 10GbE ports, eth4

and eth5, which will use bonding mode 4 and be VLAN-enabled. We shall continue with the

wizard to create the first VLAN subnet.

-------------------------------------------------------------

If you have added all subnets, then you may proceed: you will

then be shown a summary of the configuration and be given the

option to validate it, and then a further option to apply it.

Otherwise, you may continue to add further subnets.

-------------------------------------------------------------

Do you want to configure another subnet?

1 = No (default)

2 = Yes - on a new physical port set

-->2

<--Another subnet: Yes - on a new physical port set

Select the type of configuration for this subnet

(Selecting "bonded" here will create a "portset" consisting of two separate NICs bonded together) :

1 = Single port (default)

2 = Bonded ports (note ports must be the same speed to bond)

-->2

<--Bonded/Single: Bonded ports (note ports must be the same speed to bond)

Select bond configuration :

1 = eth4, eth5 (10 Gig) (default)

-->1

<--Bonding: eth4, eth5 (10 Gig)

Select the desired bonding mode :

-----------------------------------------------------------------

Note that if you select bonding mode 6, you will not subsequently

be able to add VLAN networks to this portset.

-----------------------------------------------------------------

1 = Mode 1 - Active Passive Bonding (default)

2 = Mode 4 - Link Aggregate Control Protocol (LACP) Bonding

3 = Mode 6 - Active Load Balance Bonding

-->2

<--Bonding Mode: Mode 4 - Link Aggregate Control Protocol (LACP) Bonding

---------------------------------------------------

The next question has a mandatory response, since

this is a single-node system.

---------------------------------------------------

What type of data will this network carry?

1 = both (default)

-->1

<--Data/Management/Both: both

Is this subnet on a Virtual LAN?

1 = No (default)

2 = Yes

-->2

<--VLAN/Not VLAN: Yes

Enter VLAN tag (an integer between 2 and 4094 inclusive) :

-->22

<--VLAN Tag: 22

Select Static or DHCP addressing :

1 = DHCP (default)

2 = Static

-->2

<--DHCP/Static: Static

No valid IP addresses to add.Enter an IP address for this network:

-->10.1.1.16

<--Static IP address: 10.1.1.16

Enter subnet mask :

-->255.255.255.0

<--Subnet mask: 255.255.255.0

Network configuration using net set wizard 51

Brand	HP
Model	StoreOnce 4900 Backup
Category	Storage
Language	English

HP StoreOnce 4900 Backup User Manual

Table of Contents

Questions and Answers:

HP StoreOnce 4900 Backup Specifications

Related product manuals