Installing a hard drive in the fifth hard drive bay
To install a SAS or SATA hard drive into fifth HDD bay:
1. Place the workstation on its side, and remove the three drive screws that are located on the bottom
of the chassis.
Figure 5-47 Installing screws for the hard drive in the fifth hard drive bay
2. Insert the drive into bay five and align the holes in the bottom of the hard drive with the screw holes
at the base of the chassis.
3. Insert the screws through the base, and tighten them to secure the hard drive to the chassis.
4. Attach a data cable from a SATA connector on the system board to the hard drive, and attach the
fifth drive power cable to the drive. It is attached to a clip in front of the power supply.
Figure 5-48 Attaching the data cable for the SATA hard drive in the fifth hard drive bay
5. For a SAS hard drive, attach a SAS/SATA adapter to the connector on the hard drive. Attach a
data cable from a SAS connector on the system board to the hard drive, and attach a power cable
to the drive.
98 Chapter 5 Removal and replacement procedures ENWW
To Next Page
Loading...
