●
Do not use excessive force when inserting a drive.
●
Avoid exposing a hard drive to liquids, temperature extremes, or products that have magnetic fields
such as monitors or speakers.
Lithium coin cell battery
The battery that comes with the workstation provides power to the real-time clock and has a minimum
lifetime of about three years.
For instructions on battery removal and replacement, see
Battery on page 88.
WARNING! This workstation contains a lithium battery. A risk of fire and chemical burn exists if the
battery is handled improperly. Do not disassemble, crush, puncture, short external contacts, dispose of
in water or fire, or expose it to temperatures higher than 140 degrees F (60 degrees C).
NOTE: Batteries, battery packs, and accumulators should not be disposed of with general household
waste.
Customer Self Repair
Customer Self Repair (CSR) enables you to obtain replacement parts and install them yourself on your
workstation. See
http://www.hp.com/go/selfrepair/ for more information.
Pre-disassembly procedures
After shutdown, perform the following steps before servicing the workstation:
1. Remove or disengage any security devices that prohibit opening the workstation.
2. Close any open software applications.
3. Remove any diskettes or CDs from the workstation.
4. Exit the operating system.
5. Shut down the workstation and any peripheral devices that are connected to it.
6. Disconnect the power cord from the electrical outlet and then from the workstation.
7. Disconnect all peripheral device cables from the workstation.
ENWW Customer Self Repair 55
To Next Page
Loading...
