To replace the bottom case, reverse the removal procedures.
Card reader cable
To remove the card reader cable, use this procedure and illustration.
NOTE: The card reader cable is included in the Cable Kit, spare part number N19223-001.
Before removing the card reader cable, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 41).
2. Remove the service cover (see Service cover on page 41), and then remove the following
components:
a. Battery (see Battery on page 42)
b. WWAN module thermal module (see WWAN module on page 45)
c. Memory module cover (see Memory modules on page 47)
d. Bottom case (see Bottom case on page 60)
Remove the card reader cable:
1. Disconnect the card reader cable (1) from the system board.
2. Disconnect the card reader cable (2) from the card reader board.
62
Chapter 6 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
