a. Battery (see Battery on page 42)
b. WWAN module thermal module (see WWAN module on page 45)
c. Memory module cover (see Memory modules on page 47)
d. Bottom case (see Bottom case on page 60)
e. Fans (see Fan on page 64)
f. Card reader cable (see Card reader cable on page 62)
g. System board (see System board on page 66)
Remove the card reader:
1. Remove the three Phillips M2.0 × 2.3 broadhead screws (1) that secure the card reader to the
computer.
2. Remove the card reader (2) from the computer.
To replace the card reader, reverse the removal procedures.
NFC module cable
To remove the NFC module cable, use this procedure and illustration.
The NFC module cable is available in the Cable Kit, spare part number N19223-001.
Before removing the NFC module cable, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 41).
2. Remove the service cover (see Service cover on page 41), and then remove the following
components:
a. Battery (see Battery on page 42)
b. WWAN module thermal module (see WWAN module on page 45)
c. Memory module cover (see Memory modules on page 47)
NFC module cable
75
To Next Page
Loading...
