3. Detach the card reader cable (3) from the computer. The cable is attached with double-sided
adhesive.
To replace the card reader cable, reverse the removal procedures.
Keyboard hub cable
To remove the keyboard hub cable, use this procedure and illustration.
Table 6-4
Keyboard hub cable description and part number
Description Spare part number
Keyboard hub cable
NOTE: The keyboard hub cable is included in the Cable Kit. spare part number N19223-001.
N99103-001
Before removing the keyboard hub cable, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 41).
2. Remove the service cover (see Service cover on page 41), and then remove the following
components:
a. Battery (see Battery on page 42)
b. WWAN module thermal module (see WWAN module on page 45)
c. Memory module cover (see Memory modules on page 47)
d. Bottom case (see Bottom case on page 60)
Remove the keyboard hub cable:
1. Disconnect the keyboard hub cable (1) from the keyboard hub board.
2. Disconnect the keyboard hub cable (2) from the system board.
Keyboard hub cable
63
To Next Page
Loading...
