Table 6-14 SD card reader description and part number
Description Spare part number
SD card reader
NOTE: The SD card reader cable is available in the Cable Kit, spare part number N19223-001.
N99104-001
Before removing the SD card reader, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 41).
2. Remove the service cover (see Service cover on page 41), and then remove the following
components:
a. Battery (see Battery on page 42)
b. WWAN module thermal module (see WWAN module on page 45)
c. Memory module cover (see Memory modules on page 47)
d. Bottom case (see Bottom case on page 60)
e. Fans (see Fan on page 64)
f. System board (see System board on page 66)
Remove the SD card reader:
1. Remove the three Phillips M1.5 × 2.7 screws (1) that secure the SD card reader to the computer.
2. Remove the SD card reader (2).
To replace the SD card reader, reverse the removal procedures.
SD card reader cable
To remove the SD card reader cable, use this procedure and illustration.
The SD card reader cable is available in the Cable Kit, spare part number N19223-001.
SD card reader cable
79
To Next Page
Loading...
