Before removing the SD card reader cable, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 41).
2. Remove the service cover (see Service cover on page 41), and then remove the following
components:
a. Battery (see Battery on page 42)
b. WWAN module thermal module (see WWAN module on page 45)
c. Memory module cover (see Memory modules on page 47)
d. Bottom case (see Bottom case on page 60)
e. Fans (see Fan on page 64)
f. System board (see System board on page 66)
g. SD card reader (see SD card reader on page 78)
Remove the SD card reader cable:
■
Release the ZIF connector (1), and then disconnect the SD card reader cable from the SD card reader
(2).
To replace the SD card reader cable, reverse the removal procedures.
Display assembly
To remove and disassemble the display assembly, use these procedures and illustrations.
The display assembly is available as both a full hinge-up assembly and at the subcomponent level.
Full hinge-up assembly spare part information is presented in the following table. Subcomponent-level
spare-part information is available in the following procedures.
Table 6-15
Display assembly descriptions and part numbers
Description Spare part number
HP DreamColor, WQUXGA, antiglare, 500 nits, models without a camera N99091-001
HP DreamColor, WQUXGA, antiglare, 500 nits, models with a camera N99092-001
WQUXGA, OLED, BrightView, low blue light, 400 nits, touch screen N99096-001
WQUXGA, OLED, BrightView, 400 nits, models with a camera and WWAN, touch screen N99097-001
80 Chapter 6 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
