a. Battery (see Battery on page 42)
b. WWAN module thermal module (see WWAN module on page 45)
c. Memory module cover (see Memory modules on page 47)
d. Bottom case (see Bottom case on page 60)
e. Fans (see Fan on page 64)
f. System board (see System board on page 66)
Remove the audio jack:
1. Remove the two Phillips M2.0 × 5.3 screws (1) that secure the audio jack to the computer.
2. Remove the audio jack (2) from the computer.
To replace the audio jack, reverse the removal procedures.
Fingerprint reader
To remove the fingerprint reader, use this procedure and illustration.
Table 6-11
Fingerprint reader description and part number
Description Spare part number
Fingerprint reader
NOTE: The fingerprint reader cable is included in the Cable Kit, spare part number N19223-001.
N19235-001
Before removing the fingerprint reader, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 41).
2. Remove the service cover (see Service cover on page 41), and then remove the following
components:
a. Battery (see Battery on page 42)
72
Chapter 6 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
