b. WWAN module thermal module (see WWAN module on page 45)
c. Memory module cover (see Memory modules on page 47)
d. Bottom case (see Bottom case on page 60)
e. Fans (see Fan on page 64)
f. System board (see System board on page 66)
Remove the fingerprint reader :
1. Disconnect the fingerprint reader cable (1) from the system board.
2. Remove the Phillips M2.0 × 2.3 broadhead screw (2) that secures the fingerprint reader and bracket
to the computer.
3. Detach the fingerprint reader cable (3) from the computer. The cable is attached with double-sided
adhesive.
4. Remove the fingerprint reader bracket (4).
The fingerprint reader bracket is included with the fingerprint reader spare part kit.
5. Remove the fingerprint reader (5) and cable.
To replace the fingerprint reader, bracket, and cable, reverse the removal procedures.
Fingerprint reader cable
To remove the fingerprint reader cable, use this procedure and illustration.
The fingerprint reader cable is available in the Cable Kit, spare part number N19223-001.
Before removing the fingerprint reader cable, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 41).
Fingerprint reader cable
73
To Next Page
Loading...
