a. Remove the display assembly.
b. Remove the display bezel.
c. Remove the display panel assembly.
d. Remove the motion board cable.
e. Detach the motion board from the display back cover. The motion board is attached to the
display back cover with double-sided adhesive.
The motion board is available using spare part number N10918-001.
17. To remove the sensor board cable:
a. Remove the display assembly.
b. Remove the display bezel.
c. Remove the display panel assembly.
d. Release the ZIF connector (1) the sensor board cable is connected to, and then disconnect the
sensor board cable from the sensor board.
e. Detach the sensor board cable (2) from the display back cover. The sensor board cable is
attached to the display back cover with double-sided adhesive.
Display assembly
59
To Next Page
Loading...
