HPE 3PAR StoreServ

Disabling Permissive Mode..............................................................................................28
Changing the Public Network Interface Parameters................................................................... 28
Changing the SP Default Route....................................................................................... 28
Changing the SP IP Address........................................................................................... 29
Changing the SP Netmask...............................................................................................30
Changing the SP Default Gateway.................................................................................. 30
Changing Transfer Media Settings..............................................................................................31
Changing the Transfer Media...........................................................................................31
Changing the Remote Operations Transfer Media...........................................................32
StoreServ Configuration Management................................................33
Modify StoreServ Configuration Parameters.............................................................................. 33
Maintenance Mode Overview...........................................................................................33
Add vCenter to the StoreServ..................................................................................................... 34
Add vCenter to the new StoreServ...................................................................................35
Add vCenter to the existing StoreServ............................................................................. 39
StoreServ Product Maintenance..........................................................43
Local Notification Service.................................................................... 45
Setting Up Local Notification.......................................................................................................45
Enabling Local Notification Access.................................................................................. 45
Configuring Local Notification Settings During Initial Setup............................................. 46
Using Notification Maintenance Utilities......................................................................................47
Configuring Mailhost................................................................................................................... 47
Editing the Sites Table................................................................................................................ 47
Adding a Site....................................................................................................................47
Editing the Product Table................................................................................................. 48
Adding an Entry to the Product Table....................................................................48
Editing the Product Table Entries.......................................................................... 48
Deleting a Product.................................................................................................49
Predefining Symptoms..................................................................................................... 49
Adding a Predefined Symptom..............................................................................49
Editing Predefined Symptoms............................................................................... 50
Deleting a Predefined Symptom............................................................................50
Editing Default Shifts and Exceptions......................................................................................... 50
Using the Global Default Shift Pattern............................................................................. 50
Using Prime Shift Patterns............................................................................................... 51
Using Prime Shift Exceptions...........................................................................................51
Using Default Prime Shift Exceptions....................................................................51
Adding a Prime Shift Exception.............................................................................51
Editing Default Shift Exceptions............................................................................ 52
Deleting a Prime Shift Exception...........................................................................52
Enabling and Disabling RAP Forwarding....................................................................................52
Managing Notification Records and User Profiles...................................................................... 53
Managing User Profiles...............................................................................................................53
Adding a User Profile....................................................................................................... 53
Managing Local Notification Records......................................................................................... 54
Adding a Notification Record............................................................................................54
Editing a Notification Record............................................................................................55
Deleting a Notification Record..........................................................................................55
Disabling Local Notification Access............................................................................................ 55
4