Chapter 4
Replacing components
Replacing components
This chapter describes how to remove and install the following components in the Aruba 6200M Switch
Series:
n
Power supply(ies)
n
Fan tray
There are no user-replaceable parts on the Aruba 6200F Switch Series.
The 6200M switches and their components are sensitive to static discharge. Use an antistatic wrist strap and
observe all static precautions when replacing components.
If a power supply must be removed, and then reinstalled, wait at least 5 seconds before re-installation. Otherwise,
damage to the switch may occur. The power supply needs this time to bleed off any retained power.
Replacing the fan
If a fan has failed, the fan LED will flash simultaneously with the switch Fault LED. Replace the failed
component as soon as possible.
This section is only applicable to 6200M switches.
To Remove an Existing Fan:
HPE Aruba Networking CX 6200F/M Switch Series Installation and Getting Started Guide |
50
To Next Page
Loading...
Need help?
General