Hardware options installation 30
Hardware options installation
Introduction
If more than one option is being installed, read the installation instructions for all the hardware options and
identify similar steps to streamline the installation process.
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
CAUTION: To prevent damage to electrical components, properly ground the server before
beginning any installation procedure. Improper grounding can cause electrostatic discharge.
The server blade supports up to two 2.5 inch SFF SAS, SATA, or NVMe drives. Ensure that the
appropriate backplane is installed when installing drives.
SAS/SATA drive option
CAUTION: To prevent improper cooling and thermal damage, do not operate the server
blade or the enclosure unless all drive and device bays are populated with either a component
or a blank.
1. Remove the drive blank.
2. Prepare the drive.
To Next Page
Loading...
